When you place a component in the drawing area, an input box appears where you can enter the component's value (see Figure 1 below).
|
Figure 1 |
Figure 2 |
In some input boxes, you enter the information directly into the active field (see Figure 1). In others, you only need to select a predefined (see Figure 2).
The following applies for input boxes in CET Designer:
You enter values using the keyboard.
You move between different levels (Width, Height etc.) using the Tab key. Note, to step up a level in the input box, press Shift + Tab.
You move between the different values on one level by pressing the Spacebar key. Note, to return to a previous value on the same level in the input box, press Shift + Spacebar (levels with predefined options, like Figure 2).
You select/deselect a value by pressing the Spacebar or by single-clicking on the desired value.
