On the Office Desks and Chairs tab, all the different desk modules can be stretched. You can pre-set dimensions, appearance and materials by choosing from the list boxes to the right of the headings Table Top, Height, Leg, Leg Color, Panel and Panel Color. When clicking on an arrow, a range of alternatives will be shown.
The list boxes for Table top, Height, Leg Color and Panel Color have several levels of choice.
You can choose between Wood and Plain.
In the list box for Height, you can choose three fixed heights or enter a value by choosing Custom.
In the list box Leg Color, you can choose between Metal, Plastic and Plain.
In the list box for Panel Color, you can choose between Wood, Metal, Plastic and Plain.
Note:
|
The components Round angle desk, Extension desk, circular, and Extension desk, D-shaped can be snapped against the short sides of the other tables. Extension desk, circular and Extension desk, D-shaped cannot stand on their own but have to be connected to another table. The Round angle desk however, can stand on its own.
The inner rounding (see the left desk of Figure 1) or indention (see the right desk of Figure 2) of the desks can be changed. The "radius" (see Figure 1) can be increased or decreased. The size of the rounding or indention is dependant on the size of the table top (how much the table top has been stretched or shrunk). The smallest radius is 50 mm and the largest is 1 000 mm. You decide the size of the rounding or indention by entering a value in the text field Corner.
The height of the component can be changed after it has been positioned in the drawing area: double click on the component to open the Table Settings dialog and enter a value in the Height field. Click on OK or Apply.
Figure 1 | Figure 2 |
The components Roll and hang pedestal and Hanging pen drawer snap under the desks along a line formed by the long side (front or back) of the desk. The snapping is partially limited if the leg alternatives Cantilever or End panel are used.